Table of Contents
Advertisement
addport
addport
Add Port
Use the addport command to add ATM layer services to a line.
Syntax
addport <port_num> <port_type> <line_num>
Syntax Description
port_num
port_type
line_num
Related Commands
delport, dspport, dspports
Attributes
Log: Yes
Example
Add port 8 to line 8 and define the port as a UNI port.
PXM1E_SJ.1.21.AUSMB8.a > addport 8 1 8
PXM1E_SJ.1.21.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-20
Port number for the ATM service. The port number range is 1 to 8.
Note
The available port numbers are shared by ATM ports and IMA groups.
If a port number is in use as either an ATM port number or as an IMA
group number, that port number cannot be used for other ATM ports or
IMA groups.
Type of ATM service:
•
UNI = 1
•
NNI = 2
Line number to which the port definition applies. The line number range is 1 to
8.
If a line is assigned to an IMA group, you cannot use that line for an
Note
ATM port unless you remove the line from the IMA group.
State: Active
Privilege: Group 1
Chapter 4
AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Advertisement
Table of Contents
