Cisco Nexus 7000 Series Command Reference Manual page 383
Hide thumbs
Also See for Nexus 7000 Series:
- Reference manual (746 pages) ,
- Configuration manual (536 pages) ,
- Hardware installation and reference manual (508 pages)
Table of Contents
Advertisement
H Commands
copy
f1
rl-1
rl-2
rl-3
rl-4
rl-5
layer-2
l2pt
mcast-snooping
port-security
storm-control
vpc-low
layer-3
control
glean
glean-fast
Specifies data and control packets copied to the
supervisor module. The default rate is 30000 packets
per second.
Specifies the control packets from the F1 modules to
the supervisor.
Specifies the F1 rate-limiter 1.
Specifies the F1 rate-limiter 2.
Specifies the F1 rate-limiter 3.
Specifies the F1 rate-limiter 4.
Specifies the F1 rate-limiter 5.
Specifies Layer 2 packet rate limits.
Specifies Layer 2 Tunnel Protocol (L2TP) packets.
The default rate is 4096 packets per second.
Specifies Layer 2 multicast-snooping packets. The
default rate is 10000 packets per second.
Specifies port security packets. The default is
disabled.
Specifies broadcast, multicast, and unknown unicast
storm-control packets. The default is disabled.
Specifies Layer 2 control packets over the virtual port
channel (vPC) low queue. It synchronizes
control-plane communication between vPC peer
switches that are of a lower priority and protects the
control plane when a vPC peer switch misbehaves or
excessive traffic occurs between the two. The default
rate is 4000 packets per second.
Specifies Layer 3 packet rate limits.
Specifies Layer-3 control packets. The default rate is
10000 packets per second.
Specifies Layer-3 glean packets. The default rate is
100 packets per second.
Specifies Layer 3 glean fast-path packets. The default
rate is 100 packets per second.
Cisco Nexus 7000 Series Security Command Reference
hardware rate-limiter
357
Advertisement
Table of Contents
