Table of Contents
Advertisement
How to Configure EtherSwitch HWICs
Creating a Bridge Group
To configure fallback bridging for a set of switched virtual interfaces (SVIs), these interfaces must be
assigned to bridge groups. All interfaces in the same group belong to the same bridge domain. Each SVI
can be assigned to only one bridge group.
Follow the steps below to create a bridge group and assign an interface to it.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
no ip routing
Example:
Router(config)# no ip routing
Step 4
bridge bridge-group protocol
vlan-bridge
Example:
Router(config)# bridge 100 protocol
vlan-bridge
Book Title
74
enable
configure terminal
no ip routing
bridge bridge-group protocol vlan-bridge
interface interface-id
bridge-group bridge-group
end
show vlan-bridge
show running-config
copy running-config startup-config
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Disables IP routing.
Assigns a bridge group number and specifies the VLAN-bridge
spanning-tree protocol to run in the bridge group.
The ibm and dec keywords are not supported.
•
•
For bridge-group, specify the bridge group number. The range is 1
to 255.
Frames are bridged only among interfaces in the same group.
•
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
