Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Command
Step 3
no mac-address-table secure hw-addr vlan
vlan-id
Example:
Router(config)# no mac-address-table secure
address 0100.5e05.0505 vlan vlan 1
Step 4
end
Example:
Router(config)# end
You can remove all secure addresses by using the clear mac-address-table secure command in
privileged EXEC mode.
Verifying Secure Addresses
Use the show mac-address-table secure command to verify configuration:
Router# show mac-address-table secure
Configuring Static Addresses
A static address has the following characteristics:
•
•
•
Because all ports are associated with at least one VLAN, the switch acquires the VLAN ID for the
address from the ports that you select on the forwarding map. A static address in one VLAN must be a
static address in other VLANs. A packet with a static address that arrives on a VLAN where it has not
been statically entered is flooded to all ports and not learned.
Follow these steps to add a static address.
SUMMARY STEPS
1.
2.
3.
4.
It is manually entered in the address table and must be manually removed.
It can be a unicast or multicast address.
It does not age and is retained when the switch restarts.
enable
configure terminal
mac-address-table static hw-addr [interface] interface-id [vlan] vlan-id
end
How to Configure EtherSwitch HWICs
Purpose
Enters the secure MAC address, its associated port, and
the VLAN ID to be removed.
Returns to privileged EXEC mode.
Book Title
103
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
