Cisco 10000 Series Configuration Manual page 170
Router access network control protocol
Hide thumbs
Also See for 10000 Series:
- Configuration manual (854 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
test aaa group
test aaa group
To associate a dialed number identification service (DNIS) or calling line identification (CLID) user
profile with the record that is sent to the RADIUS server or to manually test load balancing server status,
use the test aaa group command in privileged EXEC mode.
DNIS and CLID User Profile
RADIUS Server Load Balancing Manual Testing
Syntax Description
group-name
radius
username
password
new-code
profile profile-name
server ip-address
auth-port
port-number
acct-port
port-number
count n
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-38
test aaa group {group-name | radius} username password new-code [profile profile-name]
test aaa group group-name [server ip-address] [auth-port port-number] [acct-port port-number]
username password new-code [count n] [rate m] [blocked {yes | no}]
Subset of RADIUS servers that are used as defined by the server group
group-name.
Uses RADIUS servers for authentication.
Specifies a name for the user.
Caution
Character string that specifies the password.
The code path through the new code, which supports a CLID or DNIS user
profile association with a RADIUS server.
(Optional) Identifies the user profile specified in the aaa user profile
command. To associate a user profile with the RADIUS server, the user
profile name must be identified.
(Optional) For RADIUS server load balancing, specifies which server in the
server group the test packets will be sent to.
(Optional) Specifies the User Datagram Protocol (UDP) destination port for
authentication requests.
(Optional) Port number for authentication requests; the host is not used for
authentication if set to 0. If unspecified, the port number defaults to 1646.
(Optional) Specifies the UDP destination port for accounting requests.
(Optional) Port number for accounting requests; the host is not used for
accounting if set to 0. If unspecified, the port number defaults to 1646.
(Optional) Specifies how many authentication and accounting requests are
to be sent to the server for each port.
•
•
If you use this command to manually test RADIUS load balancing
server state, it is recommended that a test user, one that is not
defined on the RADIUS server, be used to protect against security
issues that may arise if the test user is not correctly configured.
Default is 1.
Range for n is 1 to 50000.
Chapter A
ANCP Command Reference
OL-14660-03
Advertisement
Table of Contents
