Cisco 10000 Series Configuration Manual page 171
Router access network control protocol
Hide thumbs
Also See for 10000 Series:
- Configuration manual (854 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter A
ANCP Command Reference
rate m
blocked {yes | no}
Command Defaults
DNIS and CLID User Profile
If this command is not enabled, DNIS or CLID attribute values are not sent to the RADIUS server.
RADIUS Server Load Balancing Manual Testing
RADIUS server load-balancing server status manual testing does not occur.
Command Modes
Privileged EXEC
Command History
Release
12.2(4)T
12.2(28)SB
12.4(11)T
12.2(31)ZV1
Usage Guidelines
The test aaa group command can be used to
•
•
Note
Examples
The following example shows how to configure a dnis = dnisvalue user profile named prfl1 and associate
it with a test aaa group command:
aaa user profile prfl1
aaa attribute dnis
aaa attribute dnis dnisvalue
no aaa attribute clid
! Attribute not found.
aaa attribute clid clidvalue
OL-14660-03
(Optional) Specifies how many requests per second is sent to the server.
•
•
(Optional) Specifies if the request is sent in blocking or nonblocking mode.
If the blocked keyword is not used:
•
•
Modification
This command was introduced.
The following keywords and arguments were added for configuring
RADIUS load balancing manual testing functionality: server ip-address,
auth-port port-number, acct-port port-number, count n, rate m, blocked.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was enhanced to show user attributes returned from
RADIUS authentication when authentication is successful.
Associate a DNIS or CLID named user profile with the record that is sent to the RADIUS server,
which can then access DNIS or CLID information when the server receives a RADIUS record.
Verify RADIUS load-balancing server status.
The test aaa group command does not work with TACACS+.
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Default is 10 requests per second.
Range for m is 1 to 1000.
Default is blocking mode if one request is sent.
Default is nonblocking mode if more than one request is sent.
test aaa group
A-39
Advertisement
Table of Contents
