Where To Go Next; Additional References - Cisco Catalyst 2960 series Configuration Manual
Vlan
Hide thumbs
Also See for Catalyst 2960 series:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Where to Go Next
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport priority extend trust
Switch(config-if)# end
To return the port to its default setting, use the no switchport priority extend interface configuration command.
Related Topics
Configuring the Priority of Incoming Data Frames, on page 101
Cisco IP Phone Data Traffic, on page 97
Where to Go Next
After configuring voice VLANs, you can configure the following:
• VLANs
• VLAN Trunking
• VLAN Membership Policy Server (VMPS)
• VTP
Additional References
Related Documents
Related Topic
For complete syntax and usage information for the
commands used in this chapter.
Standards and RFCs
Standard/RFC
—
MIBs
MIB
All supported MIBs for this release.
Catalyst 2960-X Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX
104
Document Title
Catalyst 2960-X Switch VLAN Management
Command Reference
Title
—
MIBs Link
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
Configuring Voice VLANs
OL-29065
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Table of Contents
