Configuring Fast Ethernet And Gigabit Ethernet Interfaces - Cisco 2800 Series Manual
Hide thumbs
Also See for 2800 Series:
- Introduction manual (186 pages) ,
- Quick start manual (13 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Command or Action
Step 6
show running-config
Example:
Router# show running-config
Step 7
exit
Example:
Router# exit
Examples
The following example shows how to set the console idle privileged EXEC timeout to 2 minutes 30
seconds:
line console
exec-timeout 2 30
The following example shows how to set the console idle privileged EXEC timeout to 10 seconds:
line console
exec-timeout 0 10
What to Do Next
Proceed to the
Configuring Fast Ethernet and Gigabit Ethernet Interfaces
This sections shows how to assign an IP address and interface description to an Ethernet interface on
your router.
For comprehensive configuration information on Fast Ethernet and Gigabit Ethernet interfaces, see the
"Configuring LAN Interfaces" chapter of the Cisco IOS Interface and Hardware Component
Configuration Guide.
For information on interface numbering, see the quick start guide that shipped with your router.
Note
Cisco 1841 and Cisco 2801 routers have a hardware limitation on the Fast Ethernet ports FE0/0 and
FE0/1. In half-duplex mode, when traffic reaches or exceeds 100% capacity (equal to or greater than 5
Mbps in each direction), the interface will experience excessive collisions and reset once per second. To
avoid this problem, traffic must be limited to less than 100% of capacity.
SUMMARY STEPS
1.
2.
3.
4.
OL-5593-01
"Configuring Fast Ethernet and Gigabit Ethernet Interfaces" section on page
enable
show ip interface brief
configure terminal
interface {fastethernet | gigabitethernet} 0/port
How to Perform a Basic Software Configuration Using the Cisco IOS CLI
Purpose
Displays the running configuration file.
•
Verify that you properly configured the idle privileged
EXEC timeout.
Exits privileged EXEC mode.
For the exec-timeout command to take effect, you
Note
must exit from the EXEC mode and login again.
Basic Software Configuration Using the Cisco IOS Command-Line Interface
7.
7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
