Ppp Encapsulation - Cisco 2800 Series Manual
Hide thumbs
Also See for 2800 Series:
- Introduction manual (186 pages) ,
- Quick start manual (13 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Examples of Using the Setup Command Facility to Configure Interface Parameters
The following linecode types are available:
Enter the line code type [hdb3]:
Do you want to configure Serial1/1:0 interface?: [Yes]:
Configuring the Channelized E1/T1 serial channels
Some encapsulations supported are
Choose encapsulation type
Configure IP on this interface? [no]: y
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 3.0.0.1
Subnet mask for this interface [255.0.0.0]:
Class A network is 3.0.0.0, 8 subnet bits; mask is /8
The following sections describe the prompts you for each encapsulation type. No further configuration
Note
is needed for HDLC encapsulation.
PPP Encapsulation
The following is a sample configuration for PPP encapsulation:
Would you like to enable multilink PPP [yes]:
Enter a username for CHAP authentication [Router]:remote_router
Enter a password for CHAP authentication: secret
The password, which is used by the Challenge Handshake Authentication Protocol (CHAP)
Note
authentication process, is case sensitive and must exactly match the password for the remote router.
Frame Relay Encapsulation
The following is a sample configuration for Frame Relay encapsulation:
The following lmi-types are available to be set,
when connected to a frame relay switch
Enter lmi-type [2]:
The setup command facility prompts you for the data-link connection identifier (DLCI) number only if
Note
you specify none for the LMI type. If you accept the default or specify another Local Management
Interface (LMI) type, the DLCI number is provided by the specified protocol.
Enter the DLCI number for this interface [16]:
Do you want to map a remote machine's IP address to dlci? [yes]:
IP address for the remote interface: 2.0.0.2
Do you want to map a remote machine's IPX address to dlci? [yes]:
IPX address for the remote interface: 40.1234.5678
Serial interface needs clock rate to be set in dce mode.
The following clock rates are supported on the serial interface.
Basic Software Configuration Using the Setup Command Facility
20
ami | hdb3
ppp/hdlc/frame-relay/lapb/atm-dxi/smds/x25
[0] none
[1] ansi
[2] cisco
[3] q933a
0
[ppp]:
OL-5992-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
