Ieee 802.1Q Encapsulation Configuration Task List - Cisco 1710 Software Configuration Manual

Security router

Hide thumbs Also See for 1710:

Table of Contents

Configuring Routing Between VLANs

with IEEE 802.1Q Encapsulation

This chapter describes the required and optional tasks for configuring routing

between VLANs with IEEE 802.1Q encapsulation. For complete descriptions of

the VLAN commands used in this chapter, refer to the "Cisco IOS Switching

Commands" chapter in the Cisco IOS Switching Services Command Reference.

For documentation of other commands that appear in this chapter, you can either

use the command reference master index or search online.

The IEEE 802.1Q protocol is used to interconnect multiple switches and routers

and for defining VLAN topologies. IEEE 802.1Q support is currently available

for Fast Ethernet interfaces.

The Cisco 1710 Security router supports IEEE 802.1Q only on the Fast

Note

Ethernet interface.

IEEE 802.1Q Encapsulation Configuration Task List

You can configure routing between any number of VLANs in your network. This

section documents the configuration tasks for each protocol supported with

IEEE 802.1Q encapsulation. The basic process is the same, regardless of the

protocol being routed. It involves:

78-12696-01

Enabling the protocol on the router

•

Enabling the protocol on the interface

Cisco 1710 Security Router Software Configuration Guide

C H A P T E R

4-1

Table of Contents

Show Quick Links

Table of Contents