Table of Contents
Advertisement
Configuring the Dialer Interface
Configuring the Dialer Interface
Command
Step 1
interface dialer 0
Step 2
ip address ip-address subnet-mask
Step 3
ip mtu 1492
Step 4
encapsulation ppp
Step 5
dialer pool 1
Cisco 1710 Security Router Software Configuration Guide
2-6
Statistics for Virtual Private Network (VPN) Module:
0 packets in
0 paks/sec in
0 Kbits/sec in
rx_no_endp: 0 rx_hi_discards: 0 fw_failure: 0
invalid_sa: 0 invalid_flow: 0 cgx_errors 0
fw_qs_filled: 0 fw_resource_lock:0 lotx_full_err: 0
null_ip_error: 0 pad_size_error: 0 out_bound_dh_acc: 0
esp_auth_fail: 0 ah_auth_failure: 0 crypto_pad_error: 0
ah_prot_absent: 0 ah_seq_failure: 0 ah_spi_failure: 0
esp_prot_absent:0 esp_seq_fail: 0 esp_spi_failure: 0
obound_sa_acc: 0 invalid_sa: 0 out_bound_sa_flow: 0
invalid_dh: 0 bad_keygroup: 0 out_of_memory: 0
no_sh_secret: 0 no_skeys: 0 invalid_cmd: 0
dsp_coproc_err: 0 comp_unsupported:0 pak_too_big: 0
pak_mp_length_spec_fault: 0
tx_lo_queue_size_max 0 cmd_unimplemented: 0
159405 seconds since last clear of counters
Interrupts: Notify = 0, Reflected = 0, Spurious = 0
cgx_cmd_pending:0 packet_loop_max: 0 packet_loop_limit: 512
This command can also be used as follows to verify that the VPN module is
disabled:
c1710#show crypto engine accelerator statistic
There is no crypto accelerator.
Complete the following tasks to configure the dialer interface. Start in global
configuration mode.
Chapter 2
Cisco 1710 Security Router Configuration
0 packets out
0 paks/sec out
0 Kbits/sec out
Task
Enter Dialer 0 interface configuration.
Set the IP address and subnet mask for the
Dialer 0 interface.
Set the size of the IP maximum transmission
unit (MTU).
Set the encapsulation type to PPP.
Specify the dialer pool to be used.
78-12696-01
- Quick Links:
- Using Commands
Hide quick links:
Advertisement
Table of Contents
