Cisco 300 Series Administration Manual page 303
Managed switch
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Quick start manual (72 pages) ,
- Datasheet (14 pages)
Table of Contents
Advertisement
IP Configuration
IPv4 Management and Interfaces
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
In Layer 2 mode, the IP, MAC address mapping in ARP Table is used by the device
to forward traffic originated by the device. In Layer 3 mode, the mapping
information is used for Layer 3 routing as well as to forward generated traffic.
To define the ARP tables:
Click IP Configuration > IPv4 Management and Interfaces > ARP.
Enter the parameters.
•
ARP Entry Age Out—Enter the number of seconds that dynamic addresses
can remain in the ARP table. A dynamic address ages out after the time it is
in the table exceeds the ARP Entry Age Out time. When a dynamic address
ages out, it is deleted from the table, and only returns when it is relearned.
•
Clear ARP Table Entries—Select the type of ARP entries to be cleared from
the system.
All
-
—Deletes all of the static and dynamic addresses immediately.
Dynamic
-
—Deletes all of the dynamic addresses immediately.
Static
-
—Deletes all of the static addresses immediately.
Normal Age Out
-
ARP Entry Age Out time.
Click Apply. The ARP global settings are written to the Running Configuration file.
The ARP table displays the following fields:
•
Interface—The IPv4 Interface of the directly-connected IP subnet where the
IP device resides.
•
IP Address—The IP address of the IP device.
•
MAC Address—The MAC address of the IP device.
•
Status—Whether the entry was manually entered or dynamically learned.
Click Add.
Enter the parameters:
•
IP Version—The IP address format supported by the host. Only IPv4 is
supported.
•
VLAN—In Layer 2, displays the management VLAN ID.
—Deletes dynamic addresses based on the configured
17
277
Advertisement
Table of Contents
