Verifying Single-Segment Pseudowires; Displaying Information About The L2Vpn Single-Segment Pseudowires; How To Configure Epvn-Vpws; Configuring L2Vpn Evpn Address Family Under Bgp - Cisco ASR 9000 Series Configuration Manuallines

L2vpn and ethernet services configuration guide

Hide thumbs Also See for ASR 9000 Series:

Table of Contents

Implementing Point to Point Layer 2 Services

RP/0/RSP0/CPU0:router(config-bgp-nbr-af)#

Specifies the L2VPN address family of the neighbor and enters address family configuration mode.

Use the commit or end command.

commit - Saves the configuration changes and remains within the configuration session.

end - Prompts user to take one of these actions:

• Yes - Saves configuration changes and exits the configuration session.

• No - Exits the configuration session without committing the configuration changes.

• Cancel - Remains in the configuration mode, without committing the configuration changes.

Verifying Single-Segment Pseudowires

To verify the connectivity in SS-PWs, use the ping mpls pseudowire command.

The show commands are used to display information about L2VPN Single Segment Pseudowires

• show bgp l2vpn mspw

• show l2vpn pwr summary

• show l2vpn xc

The following steps are performed to configure EVPN-VPWS:

Perform this task to configure L2VPN EVPN address family under BGP:

SUMMARY STEPS

1. configure

2. router bgp autonomous-system-number

3. address-family l2vpn evpn

4. neighbor ip-address

5. address-family l2vpn evpn

6. Use the commit or end command.

DETAILED STEPS

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

address-family l2vpn mspw

Verifying Single-Segment Pseudowires