Default Settings For Dhcp - Cisco Nexus 9000 Series Configuration Manual
Nx-os security configuration guide, release 9.x
Hide thumbs
Also See for Nexus 9000 Series:
- Configuration manual (276 pages) ,
- Troubleshooting manual (126 pages) ,
- Quick start configuration manual (6 pages)
Table of Contents
Advertisement
Default Settings for DHCP
• If an ingress router ACL is configured on a Layer 3 interface that you are configuring with a DHCP
• If you use DHCP relay where DHCP clients and servers are in different VRFs, use only one DHCP server
• Access-control list (ACL) statistics are not supported if the DHCP snooping feature is enabled.
• Make sure that the DHCP configuration is synchronized across the switches in a vPC link. Otherwise, a
• DHCP smart relay is limited to the first 100 IP addresses of the interface on which it is enabled.
• You must configure a helper address on the interface in order to use DHCP smart relay.
• In a vPC environment with DHCP smart relay enabled, the subnet of the primary and secondary addresses
• When you configure DHCPv6 server addresses on an interface, a destination interface cannot be used
• The following guidelines and limitations apply to the DHCP client feature:
Note
For DHCP configuration limits, see the Cisco Nexus 9000 Series NX-OS Verified Scalability Guide.
Default Settings for DHCP
This table lists the default settings for DHCP parameters.
Table 32: Default DHCP Parameters
Parameters
DHCP feature
DHCP snooping
DHCP snooping on VLANs
DHCP snooping MAC address verification
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
336
server address, make sure that the router ACL permits DHCP traffic between DHCP servers and DHCP
hosts.
within a VRF.
run-time error can occur, resulting in dropped packets.
of an interface should be the same on both Cisco NX-OS devices.
with global IPv6 addresses.
• You can configure multiple SVIs, but each interface VLAN should be in a different subnet. The
DHCP client feature cannot configure different IP addresses with the same subnet on different
interface VLANs on the same device.
• DHCP client and DHCP relay are not supported on the same switch.
• DHCP client is not supported for Layer 3 subinterfaces.
• DHCP client is supported on the Cisco Nexus 9300 Series switches and the Cisco Nexus 9500 Series
switches.
Default
Disabled
Disabled
Disabled
Enabled
Configuring DHCP
- Quick Links:
- Radius and Tacacs+ Security Protocols
Hide quick links:
Advertisement
Table of Contents
