Configuring Static Routes Between The Pe And Ce Routers - Cisco CRS Configuration Manual
Ios xr virtual private network
Hide thumbs
Also See for CRS:
- Configuration manual (430 pages) ,
- User manual (304 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Connecting MPLS VPN Customers
• redistribute ospf process-id [ match { external [ 1 | 2 ] | internal | nssa-external [ 1 | 2 ] } ] [ route-policy name
]
• redistribute static [ route-policy name ]
Example:
RP/0/RP0/CPU0:router(config-rip-vrf)# redistribute connected
Causes routes to be redistributed into RIP. The routes that can be redistributed into RIP are:
• Border Gateway Protocol (BGP)
• Connected
• Enhanced Interior Gateway Routing Protocol (EIGRP)
• Intermediate System-to-Intermediate System (IS-IS)
• Open Shortest Path First (OSPF)
• Static
Step 8
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Static Routes Between the PE and CE Routers
Perform this task to configure provider edge (PE)-to-customer edge (CE) routing sessions that use static routes.
You must remove IPv4/IPv6 addresses from an interface prior to assigning, removing, or changing an
Note
interface's VRF. If this is not done in advance, any attempt to change the VRF on an IP interface is rejected.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
210
Implementing MPLS Layer 3 VPNs
Advertisement
Table of Contents
