Table of Contents
Advertisement
Setting up and connecting
Electrical connections
■
Before you connect up, compare the connection data (voltage and frequency)
on the plate of the appliance with that of your electrical network. This data
must match in order to avoid damage to the appliance.
■
Check to ensure that the power cable of the appliance is undamaged and it
will not be laid over hot surfaces and/or sharp edges.
■
Make sure that the power cable is not over taut or folded.
■
Do not let the power cable hang over edges (trip wire eff ect).
Inserting batteries into the remote control
NOTICE
►
The supplied battery (3V, type CR 2032) has already been fi tted into the
remote control at the factory. Before use, remove the insulation strip from
the battery compartment.
To insert a new battery, proceed as follows:
Open the battery compartment at the rear of the remote control
rotating the circular cover in the direction of the symbol
coin for turning it.
Insert a battery of the type CR 2032 (3V) into the battery compartment.
Make sure the polarities are correct; the positive pole faces up.
Close the battery compartment by replacing the round cover and turning it
in the direction of the symbol
Fixing the air-bubble mat into the bath
DANGER
Slippery!
If the air bubble mat is not fi xed into the bathtub properly,
there is a great risk of slipping!
Observe the following safety information to avoid the risks of slipping:
►
Carefully press the air-bubble mat onto the bottom of the bath tub until all
of the suction cups on the air-bubble mat are fi rmly secured to the bath
bottom.
►
Check every time before getting into the bath tub whether the air-bubble
mat is still properly and fi rmly secured.
►
Do not climb into the bathtub before all the suction cups of the air-bubble
mat are properly secured in the bath tub.
SLB 450 A1
until it is fi rmly seated back in the housing.
9
by
. Use a small
9
GB
IE
CY
Hide quick links:
Advertisement
Table of Contents
