05-4446A01, Rev. D
•
Alarmed
—The unit has detected one or more alarms that have
not been cleared.
At Remote:
•
Scanning
—The unit is looking for an Access Point beacon
signal.
•
Ranging
—Unit is adjusting power, timing, and frequency
with an AP.
•
—The unit has found a valid beacon signal for its
Connecting
network.
•
Authenticating
•
Associated
—The unit has successfully synchronized and
associated with an Access Point.
•
Alarmed
—The unit is has detected one or more alarms that
have not been cleared.
NOTE: If an alarm is present when this screen is displayed, an "A)"
appears to the left of the
key on your keyboard takes you directly to the "Current
Alarms" screen.
•
Associated Remotes
Remotes that have achieved association with the AP.
•
Connection Status
Remote has an RF connection with an AP.
•
Satellite Fix Status
achieved synchronization with GPS satellite signals.
•
Uptime
—Elapsed time since the transceiver was last booted up.
•
Firmware Version
the unit.
•
Hardware Version
circuit board.
•
Serial Number
—Make a record of this number. Provide this num-
ber when purchasing Authorization Codes to upgrade unit capa-
bilities in the future.
3.3.2 Main Menu
The Main Menu
(Figure 3-10/Figure
user-controllable features. The transceiver's
top of this and all other screens as a reminder of the unit you are cur-
rently controlling.
Mercury Reference Manual
—Device is attempting device authentication.
Device Status
(AP Only)—Indicates the number of
(Remote Only)—Indicates whether the
—Indicates whether internal GPS receiver has
—Version of firmware that is currently active in
— Hardware version of the transceiver's printed
(See "Authorization Codes" on Page
3-11) is the entry point for all
Device Name
field. Pressing the "A"
135.)
appears at the
43