Table of Contents
Advertisement
2..
IDE.connector.(40-1.pin.PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There
are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black,
and gray. Connect the blue connector to the motherboard's IDE connector, then
select one of the following modes to configure your device.
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra
DMA cable connector. This prevents incorrect insertion when you connect the
IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device jumpers
have the same setting.
ASUS V-Series P5G45
Drive.jumper.setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode.of.
Cable.connector
device(s)
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
4-7
Advertisement
Table of Contents
