Advertisement
Quick Links
INSTALLATION AND SETUP GUIDE
TYPICAL INSTALLATION
GENERAL INFORMATION
The 5818 Recessed Door Transmitter is a
reed switch, magnetic-contact sensor that
provides concealed protection for a door.
It is intended for use only with alarm
systems that support 5800 series devices.
The transmitter is powered by long-life
lithium battery that is easily replaceable
when a low battery is indicated by the
control.
PROGRAMMING THE ID NUMBER
Each
5818
has
its
identification
code
permanently
assigned
facture.
You must "enroll" the transmitter's ID
during installation of the alarm system.
5818 transmitters must be enrolled as
"RF" (supervised RF) Type (mandatory for
UL installations).
PRELIMINARY CONSIDERATIONS
Read all of this and the next section
before installing the unit.
1. Select a location for the transmitter
on the frame of the door (never on
the hinged edge) to be protected.
• Do not use on metal frame doors.
•
The transmitter will require a 7/8"
diameter hole in the edge of the
frame, at least 5" deep and its
magnet will need a 1/2" diameter hole
in the edge of the door at least 1-3/4"
deep.
BEFORE DRILLING ANY HOLES, SEE
STEP 2 BELOW AND READ ALL
OFMOUNTING.
own
unique
(serial
number)
2. Before drilling any holes, tape the
during
manu-
MOUNTING
1. Mark the selected location for the
N7022V3 4/05 Rev. A
5818 Recessed Door Transmitter
• The preferred direction of mounting is
vertical, although the 5818 may be
mounted
in
any
satisfactory
reception
transmissions is obtained.
• A physical barrier (e.g., a molding
strip on the door frame) should be
present to protect against defeat of
the
contact
from
premises.
transmitter
and
magnet
approximate locations (with battery
installed and unit together as described
under
BATTERY
INSTALLATION/
REPLACEMENT (below) and conduct
Go/No Go tests (refer to control panel's
instructions) to verify adequate signal
strength. Reorient or relocate trans-
mitter if necessary.
• Make sure that no more than 1/2"
gap exists between the faces of the
transmitter and magnet cases when
they are installed and set.
• When installed, an alarm signal must
be obtained before a clear space of
2" is reached as the door is opened.
transmitter on the frame of the door.
direction
if
of
its
outside
the
in
their
Advertisement
Related Manuals for Honeywell 5818
Summary of Contents for Honeywell 5818
- Page 1 TYPICAL INSTALLATION BEFORE DRILLING ANY HOLES, SEE GENERAL INFORMATION STEP 2 BELOW AND READ ALL The 5818 Recessed Door Transmitter is a OFMOUNTING. reed switch, magnetic-contact sensor that • The preferred direction of mounting is provides concealed protection for a door.
- Page 2 (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. CANADA: 573F-58181 165 Eileen Way, Syosset, New York 11791 ÊN7022V3GŠ Copyright © 2004 Honeywell International Inc. www.honeywell.com/security N7022V3 4/05 Rev. A...