Address (Vrrp) - Cisco Nexus 3548 Command Reference Manual
Nx-os unicast routing command reference
Hide thumbs
Also See for Nexus 3548:
- Command reference manual (247 pages) ,
- Configuration manual (230 pages) ,
- Installation manual (112 pages)
Table of Contents
Advertisement
address (VRRP)
address (VRRP)
To add a single, primary IP address to a virtual router, use the address command. To remove an IP
address from a virtual router, use the no form of this command.
Syntax Description
ip-address
secondary
Command Default
None
Command Modes
VRRP configuration mode
Command History
Release
5.0(3)A1(1)
Usage Guidelines
You can configure one virtual router IP address for a virtual router. If the configured IP address is the
same as the interface IP address, this switch automatically owns the IP address. You can configure an
IPv4 address only.
The master VRRP router drops the packets addressed to the virtual router's IP address because the virtual
router is only intended as a next-hop router to forward packets. In NX-OS devices, some applications
require that packets addressed to the virtual router's IP address be accepted and delivered. By using the
secondary option to the virtual router IPv4 address, the VRRP router will accept these packets when it
is the master.
This command requires the LAN Base Services license.
Examples
This example shows how to configure a virtual router IP address:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# vrrp 250
switch(config-if-vrrp)# address 10.0.0.10
This example shows how to remove all the IP addresses (primary and secondary) using a single
command:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# vrrp 250
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
8
address ip-address [secondary]
no address [ip-address [secondary]]
Virtual router address (IPv4). This address should be in the same subnet as
the interface IP address.
(Optional) Specifies a secondary virtual router address.
Modified
This command was introduced.
Chapter
Unicast Routing Commands
OL-27852-01
Advertisement
Chapters
Table of Contents
