Ip Local-Proxy-Arp - Cisco Nexus 3548 Command Reference Manual
Nx-os unicast routing command reference
Hide thumbs
Also See for Nexus 3548:
- Command reference manual (247 pages) ,
- Configuration manual (230 pages) ,
- Installation manual (112 pages)
Table of Contents
Advertisement
ip local-proxy-arp
ip local-proxy-arp
To enable the local proxy Address Resolution Protocol (ARP) feature, use the ip local-proxy-arp
command. To disable this feature, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Interface configuration mode
Subinterface configuration mode
Command History
Release
5.0(3)A1(1)
Usage Guidelines
Before the local proxy ARP feature can be used, you must enable the IP proxy ARP feature by using the
ip proxy-arp command. The IP proxy ARP feature is disabled by default.
This command is not applicable to Layer 3 loopback interfaces.
Note
This command requires the LAN Base Services license.
Examples
This example shows how to enable the local proxy ARP:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# ip arp local-proxy-arp
switch(config-if)#
Related Commands
Command
copy running-config
startup-config
ip proxy-arp
show ip arp
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
172
ip local-proxy-arp
no ip local-proxy-arp
Modification
This command was introduced.
Description
Saves the configuration to the startup configuration file.
Enables proxy ARP on an interface.
Displays ARP configuration information.
Chapter
Unicast Routing Commands
OL-27852-01
Advertisement
Chapters
Table of Contents
