Advertisement
Quick Links
GE Appliances & Lighting
Part Instruction
To avoid personal injury, disconnect
power before servicing this product.
Kit Includes
WE1M504
Drum Slides White -2
WE1M1067
Drum Slides Green -2
WE3M26
Top Bearing
WE12M29
Drive Belt
WE9M30
Drum Felt
WH00X5630 Instructions
Remove the Dryer Top Panel
The top panel is fastened at the front by 2
screws. On some models it also may be
secured at the rear by 3 lock tabs that
protrude from the bottom of the control
panel.
To remove the top panel:
1. Remove 2 screws that secure the
top panel to the cabinet.
GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
2. Pull the top cover toward you while
lifting up the front edge to release
the side catches. On some models
you may need to slide the top
cover to the left to release it from
the 3 locking tabs.
-1
-1
-1
-1
To remove the front panel:
1. Remove 2 screws from the front
inside edge of the front panel.
2.
Tilt the top edge of the front panel
out and disconnect wiring to the
door switch, light, and sensor rods
(if present) as shown below.
WE49X20697
WH00X5630
Advertisement
Related Manuals for GE WH00X5630
Summary of Contents for GE WH00X5630
- Page 1 GE Appliances & Lighting Part Instruction WE49X20697 2. Pull the top cover toward you while To avoid personal injury, disconnect lifting up the front edge to release power before servicing this product. the side catches. On some models you may need to slide the top cover to the left to release it from the 3 locking tabs.
- Page 2 GE Appliances & Lighting Part Instruction WE49X20697 To remove the drum slide top bearing assembly: 1. Remove the light bulb (if present). 2. Grasp the top of the drum slide bearing assembly and pull down and inward to release the assembly from the 2 tabs located at the top of the front panel.
- Page 3 GE Appliances & Lighting Part Instruction WE49X20697 2. Remove the belt from the motor pulley and remove through the front of the dryer. Drum Seal/Felt The drum seal/felt WE9M30 can be To install the drive belt: replaced by removing the seal from the 1.