Siemens SINUMERIK 840Di Function Manual page 289

Basic machine

Hide thumbs Also See for SINUMERIK 840Di:

Table of Contents

The parameters in the "Drive" service display are not necessary for connecting drives via the

PROFIBUS DP. For SINUMERIK 840Di, the drives are defined as PROFIBUS nodes. The

appropriate service data is displayed in 840DiStartup in the menu Diagnostics -->

The diagnostic options are used for:

• Checking the status of enabling and control signals

• Checking the status of FDD/MSD operating modes

• Displaying temperature warnings

• Checking the current setpoint/actual value display

• Checking the drive status (drive ready)

• Displaying the current ramp-up phase

• Displaying the group error message (message status class 1)

• Displaying the drive status messages

Service HMI Advanced Drive

Descriptions on how to select and operate the "Diagnostics" area can be found in

References: /BAD/, "HMI Advanced Operator's Guide"

/BEM/, "HMI Embedded Operator's Guide"

The individual status displays, warnings, messages, etc., are explained in the following

sections. For HMI SW 6 and higher, the status is shown in plain text as "yes" or "no" instead

of "0" and "1".

For additional information, see:

References: /IAD/, "Installation and Start-Up Guide"

Diagnostic Tools (D1)

Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0

(e.g. pulse enable, drive enable, motor selection, setpoint parameter set)

(e.g. setup mode, parking axis)

(e.g. actual position value measuring system 1/2, speed setpoint, actual speed value)

(e.g. threshold torque not reached, minimum speed not reached, actual speed = set

2.4 Drive service display (for digital drives only)

Detailed Description

Show Quick Links

Chapters

Table of Contents