Logging On To The Web User Interface - IBM TS3100 Setup, Operator, And Service Manual
Tape library
Hide thumbs
Also See for TS3100:
- Setup, operator, and service manual (375 pages) ,
- Installation quick reference manual (45 pages) ,
- Quick manual (14 pages)
Table of Contents
Advertisement
c. Press SELECT to highlight the digitsin the next octet of your IP address.
d. After the digits for the last octet are entered, press SELECT to apply your entries.
7. Press DOWN to select Netmask. For IPv4, enter an IPv4 Netmask address. For IPv6, enter an IPv6
Netmask address. For IPv4 & IPv6, enter both IPv4 and IPv6 Netmask addresses.
a. Press SELECT to highlight the Netmask field.
b. Press UP or DOWN to select the digits in the first octet of your library's Netmask address.
c. Press SELECT to highlight the digits in the next octet of your library's Netmask address.
d. After the digits for the last octet of your Netmask address are entered, press SELECT to apply
your entries.
8. Press DOWN to select Gateway. For IPv4, enter an IPv4 Gateway address. For IPv6, enter an IPv6
Gateway address. For IPv4 & IPv6, enter a Gateway address for both IPv4 and IPv6.
a. Press SELECT to highlight the Gateway field.
b. Press UP or DOWN to select the digits in the first octet of your library's Gateway address.
c. Press SELECT to highlight the digits in the next octet of your library's Gateway address.
d. After the digits are entered for the last octet in your Gateway address, press SELECT to apply
your entries.
9. Press DOWN to select Ethernet.
a. Press DOWN to highlight the Ethernet field.
b. Press SELECT to highlight the Ethernet setting.
c. Press DOWN to select a new setting.
d. Press SELECT to apply the new setting.
10. Press DOWN to highlight SAVE. Press DOWN again to highlight CANCEL. Continue to press the
DOWN to switch between SAVE and CANCEL.
v
If SAVE is highlighted, press SELECT to apply your new configuration. If changes were made to
the Network settings, a menu displays the option to reboot the library or cancel the reboot. If you
select CANCEL in the menu, you must power cycle the library for the network changes to be
applied.
v
If CANCEL is highlighted, press SELECT to cancel all of your entries and return to the
Configure menu.
Logging on to the Web User Interface
About this task
To complete the configuration of your library with the Web User Interface, follow the steps.
Procedure
1. On your host computer, open an Internet browser.
2. In the browser address field, enter your library's IP address.
a. For DHCP or Stateless Autoconfig, use the Operator Control Panel to determine the IP address
that is assigned to your library. Navigate to Monitor > Library > Network. Scroll down to the
library address information and make note of the address. Enter the IP address in your internet
browser address field to access your library with the Web User Interface. The library address
information might include one or more of the following address types:
v IP address (IPv4 static or DHCP)
v Static IPv6 address
v Link Local IPv6 address
v Assigned IPv6 address (DHCP or Stateless Autoconfig)
b. For IPv4, enter your library's IP address with the 0.0.0.0 format (four octets).
c. For IPv6, enter your library's IP address with the format: http://[0:0:0:0:0:0:0:0].
Installation and configuration
59
- Quick Links:
- Front Panel
Hide quick links:
Advertisement
Table of Contents
