Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual page 138
Hide thumbs
Also See for MAXPRO NVR Hybrid XE:
- Hardware installation and configuration manual (360 pages)
Table of Contents
Advertisement
C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
4.
Note:
Caution:
Note:
138
Under the Camera screen, select a camera to change the default parameters for the
following settings.
•
Enable/Disable - Enables or disables a camera for recording and live video. By
default the check box corresponding to a camera to enable live video preview is
selected. To disable live video preview, clear the check box corresponding to a
camera. The live video appears under Preview at the bottom right corner of the
camera General/Primary Stream page See the
section on page
141
for more information.
•
Number - Displays the camera number. You cannot modify the camera number.
•
Camera Name - Displays the camera name. You can type a new camera name
limited to a maximum of 50 alphanumeric characters.
•
IP Address - Displays the IP address of the camera. You can type the new IP
address for the camera as applicable. The IP address should include the Port
number 80. For example if the IP address is 111.221.0.333 then you should add the
port number (80) as 111.222.0.333:80.
•
Camera Type - Displays the type of camera.
•
For the camera type, "Generic - RTSP, you must specify the RTSP settings for
the camera in the camera properties. See the
Cameras/Encoders
•
To add the discovered multi-channel encoders, see the
Adding Multi-channel Encoders
•
User Name- Displays the default user name, "admin" for the camera. You can type a
new user name for the camera as applicable. Change this only if the user has been
changed on the camera.
•
Password - Displays the password, if any, for the camera. You can type a new
password for the camera as applicable. Change this only if the password has been
changed on the camera.
The camera Username and Password in the NVR needs to match the
username and password configured on the device for the NVR to be able
to connect to the camera and get video.
•
Device Stream No - Displays the channel ID. You cannot modify this field.
•
Unique System No - Display the unique camera ID. You can modify and assign a
new number as applicable.
• Unique System Number can be used to assign a unique camera number
across all your NVRs. This helps in having an unique camera number in your
entire system.
• Unique System Number should not be modified for the NVRs upgraded from
older versions to 4.0.
Configuring the Camera Properties
Adding RTSP
section on page
154
for more information.
section on page 151.
MAXPRO NVR 5.6 Installation and Configuration Guide
Discovering and
Advertisement
Table of Contents
