Advertisement
Quick Links
Cargo Bed Kit
Workman
Model No. 07046
This product contains a chemical or chemicals known to the State of California to
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
damage. Replace any decal that is damaged or missing.
1. Falling, crushing hazard, bystanders—no riders on the machine
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX Utility Vehicle
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
Rear cargo-box-accessory mount
Flange-head bolt (5/16 x 3/4 inch)
Cargo bed support (right)
Cargo bed support (left)
Flange-head bolt (5/16 x 3/4 inch)
Bolt (1/2 x 4-1/2 inches)
Flange nut
Register at www.Toro.com.
WARNING
CALIFORNIA
115-7739
Qty.
1
8
1
1
8
2
2
Form No. 3410-771 Rev B
Installation Instructions
Use
Install the rear cargo-box-accessory
mount.
Install the cargo bed supports.
Install the cargo box.
Original Instructions (EN)
All Rights Reserved *3410-771* B
Printed in the USA
decal115-7739
Advertisement
Related Manuals for Toro 07046
Summary of Contents for Toro 07046
- Page 1 Form No. 3410-771 Rev B Cargo Bed Kit Workman ® GTX Utility Vehicle Model No. 07046 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installing the Rear Installing the Cargo Bed Cargo-Box-Accessory Mount Supports Parts needed for this procedure: Parts needed for this procedure: Rear cargo-box-accessory mount Cargo bed support (right) Flange-head bolt (5/16 x 3/4 inch) Cargo bed support (left) Flange-head bolt (5/16 x 3/4 inch) Procedure Procedure 1.
- Page 3 Installing the Cargo Box Parts needed for this procedure: Bolt (1/2 x 4-1/2 inches) Flange nut g191980 Figure 4 Procedure 1. Prop rod 2. Key hole (prop-rod slot) 1. Park the machine on a level surface, engage the parking brake, shut off the engine, and remove the key from 6.
- Page 4 Adjusting the Cargo-Box Latches No Parts Required Procedure g034021 Figure 7 If the cargo-box latch is out of adjustment, the cargo box 1. Service position detent 3. Dump position detent slot vibrates up and down as you drive the machine. You can slot adjust the latch posts to make the latches hold the cargo box 2.