Table of Contents
Advertisement
Attaching the Bottom-Support Rails to the Rack
• Port-side exhaust (blue coloring for fan modules) airflow requires that the bottom-support rail with the
Warning
Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Before you begin
Before you can install the bottom support rails for the chassis, you must do the following:
• Verify that a four-post rack or cabinet is installed.
• If any other devices are stored in the rack or cabinet, verify that the heavier switches are installed below
• Verify that the bottom-support rails kit is included in the switch accessory kit.
• Verify that you have 8 screws for attaching the bottom support brackets to the racks (typically M6 x 10
Warning
Statement 1006 Chassis Warning for Rack-Mounting and Servicing
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
Step 1
Look at the fan and power supply modules installed in the chassis to determine how you must position the bottom-support
rails on the rack.
• If the fan modules have blue coloring (port-side exhaust modules), you must position the bottom support rails so
that the chassis stop is positioned by the cold aisle.
• If the fan modules have burgundy (port-side intake modules), you must position the bottom support rails so that the
chassis stop is positioned by the hot aisle.
Step 2
Separate the two sliders that make up one bottom-support rail and position the half with the chassis stop by the appropriate
aisle for the fan and power supply modules. Also make sure that there is at least 1 rack unit open above the bottom-support
rails so that you can easily install the chassis.
Cisco Nexus 9364C NX-OS Mode Switch Hardware Installation Guide
22
chassis stop be located on the cold aisle side of the rack.
lighter switches.
mm screws or the screw appropriate for the vertical mounting rails on the rack.
heaviest component at the bottom of the rack.
unit in the rack.
Installing the Chassis
- Quick Links:
- Overview of Network Connections
Hide quick links:
Advertisement
Table of Contents
