Cisco Threat Grid M5 Hardware Installation Manual page 33

Hide thumbs Also See for Threat Grid M5:

Table of Contents

Rack-Mount the Chassis

Figure 28: Attach the Inner Rail to Side of Chassis

Front of chassis

Step 2

Open the front securing plate on both slide-rail assemblies. The front end of the slide-rail assembly has a spring-loaded

securing plate that must be open before you can insert the mounting pegs into the rack-post holes.

On the outside of the assembly, push the green arrow button toward the rear to open the securing plate.

Figure 29: Front Securing Mechanism, Inside of Front End

Front mounting pegs

Securing plate shown pulled back to open position

Step 3

Install the slide rails into the rack:

a) Align one slide-rail assembly front end with the front rack-post holes that you want to use.

The slide rail front end wraps around the outside of the rack post and the mounting pegs enter the rack-post holes

from the outside-front.

The rack post must be between the mounting pegs and the open securing plate.

Note

b) Push the mounting pegs into the rack-post holes from the outside-front.

c) Press the securing plate release button, marked "PUSH." The spring-loaded securing plate closes to lock the pegs in

place.

d) Attach the second slide-rail assembly to the opposite side of the rack. Make sure that the two slide-rail assemblies

are at the same height with each other and are level front-to-back.

e) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.

Locking clip on inner rail

Rack post

Cisco Threat Grid M5 Hardware Installation Guide

Rack-Mount the Chassis

Table of Contents