Table of Contents
Advertisement
Configuring Global Parameters
Procedure
Step 1
Your system is booting and if you answer No, at the prompt:
Example:
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Then Press Return to enter user EXEC mode. The following prompt appears:
Router>
Step 3
From user EXEC mode, enter the enable command as shown in the following example:
Router> enable
Step 4
At the password prompt, enter your system password. If an enable password has not been set on your system,
this step may be skipped. The following example shows entry of the password called enablepass :
Password: enablepass
Step 5
When your enable password is accepted, the privileged EXEC mode prompt appears: Router#
Step 6
You now have access to the CLI in privileged EXEC mode and you can enter the necessary commands to
complete your desired tasks. To exit the console session, enter the quit command as shown in the following
example:
Example:
Router# quit
Configuring Global Parameters
When you first start the setup program, you must configure the global parameters. These parameters are used
for controlling system-wide settings. Perform the following steps to enter the global parameters:
Procedure
Step 1
Connect a console terminal to the console port, and then boot the router.
Note
When you see this information, you have successfully booted your router:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Cisco ASR 907 Router Hardware Installation Guide
152
--- System Configuration Dialog ---
This is only an example of the output display; prompts may vary.
Cisco Router Initial Configuration
Advertisement
Table of Contents
