Honeywell Notifier DA-60 Product Installation Document

Download this manual

1. Product Overview

The DA-60 Building Occupant Warning System (BOWS) provides emergency tones and voice messages through

100V loudspeakers to aid in the evacuation of occupants from buildings during emergency situations.

2. Installation

WARNING: Installation should be performed by competent persons in accordance with the

relevant standards as required for the installation. Honeywell Ltd accepts absolutely no liability

for the suitability, placement or settings of the speakers within an installation.

1. Remove power from the panel.

2. Fit the supplied standoffs to the CHS style mounting plate.

3. Mount the DA-60 as shown in Figure 1 and use the supplied screws to fasten it to the CHS mounting plate.

4. Connect the 20 way ribbon cable from the DA controller & pre-amp to the DA-60 using the 20 way header

as per Figure 1.

5. Wire in the 24V battery backed power supply to the 0V and 24V terminals on the DA-60; see Figure 2.

6. Complete the pre power up checks as described in the DA manual prior to applying power to the DA-60.

7. Refer to the DA manual for information on programming and connection of ancillaries.

NOTE: Do not remove the red jumper fitted to the ribbon cable header on the left hand

side of the DA-60 unless networking with another DA module. Refer to manual for

detailed connection and programming information of networked systems.

ECN09-053

Figure 1 - DA-60 on CHS-3L connected to DA Controller & Preamp

Notifier 60W Digital Amplifier (DA-60)

Product Installation Document

9 Columbia Way

Baulkham Hills, NSW 2153

PH 02-9894-1444 • FAX 02-9894-4193

www.notifier.com.au

1.00

16/07/2009

Rev:

DOC-03-007

ECN09-053

Page 1 2. Installation WARNING: Installation should be performed by competent persons in accordance with the relevant standards as required for the installation. Honeywell Ltd accepts absolutely no liability for the suitability, placement or settings of the speakers within an installation. 1. Remove power from the panel.
Page 2 Figure 2 - DA-60 Connection Diagram 3. Components The DA-60 kit (ASY-02-003) is supplied with the components outlined in Table 1. Part No. Description PCA-01-009 DA-60 BOWS – 60W Digital Amplifier with built-in tones and voice messages GEN-01-001 4-40 x 5/16” SEMS Philips head screw GEN-01-002 4-40 UNC Spacers, 19mm height 47K, 1 Watt resistor fitted to the speaker output...