Preparations; Installation - AEG MTH 350 Operation And Installation
Hydraulically controlled, open vented small instantaneous water heater with bare wire heating system
Hide thumbs
Also See for MTH 350:
- Operation and installation (80 pages) ,
- Operating and installation instructions (22 pages) ,
- Operating and installation instructions (12 pages)
Table of Contents
Advertisement
Available languages
Available languages
8.2 Accessories
Special aerator
◦ for MTH 350 and MTH 440
◦ for MTH 570
Note
Fitting the special aerator supplied provides an op-
timum water jet.
Non-pressurised taps
◦ AHo 40 MTH - non-pressurised wall mounted tap
◦ AHu 40 MTH - non-pressurised twin lever basin tap
◦ AHEu 40 MTH - non-pressurised mono lever basin
tap
9.
Preparations
» Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
» Use suitable taps (see chapter „Appliance descrip-
tion / Accessories").
10. Installation
10.1 Installation site
Install the appliance in a room free from the risk of frost
and near the draw-off tap.
Ensure that the lateral fixing screws for the cover are
always accessible.
The appliance is suitable for undersink installation (water
connections at the top) and oversink installation (water
connections at the bottom).
DANGER Electrocution
Protection rating IP25 is only ensured if the appli-
ance back panel is fitted.
» Always fit the appliance back panel.
Installation
33
Advertisement
Chapters
Table of Contents
Troubleshooting
