4. Capacity and selection data
b) Selection of the Domestic Hot Water Tank accessory
The Domestic Hot Water Tank accessory applicable to the YUTAKI S80 system is the DHWS195S-2.0H1E or DHWS260S-
2.0H1E depending on the water demand and the combination system. In order to meet the suitable tank it is necessary to
estimate the daily domestic hot water demand. The following expression is used to calculate this consumption:
Where:
D
(T): Water demand at T temperature.
i
D
(60ºC): Domestic hot water demand at 60ºC.
i
T: Domestic hot water tank's temperature.
T
: Inlet cold water temperature.
i
-
Calculation of D
(60ºC):
i
To calculate the domestic hot water demand
installation legislation of the country where the installation will be performed, in order to know the standard
liters per person each day. This is necessary to estimate the consumption in relation with the users of the
installation. For the next example the domestic hot water demand at 60º it has been taken 30 liters per
person, in a detached house with 4 persons (3 bedrooms).
-
Calculation of T:
The domestic hot water tank's temperature should be estimated. It is referred to the accumulated water
temperature inside the tank, before the use. Habitually the temperature's rank is between 45ºC - 65ºC. In
the example below, it has been taken 45ºC.
-
Calculation of T
:
i
The inlet cold water temperature is the temperature of the water that is filling the tank. The cold water
rank's temperature is 10ºC - 15ºC. To calculate an approximate water demand it has been used 12ºC.
-
Example:
D
(T)= 120 x (60-12 / 45-12) = 174.6 litres/day (*)
i
N O T E
(*): Depending on the electric tariff, the installation space and the cost/efficiency relation there are different
strategies of accumulation to follow. In case a low cost electric tariff strategy is choosen (accumulation strat-
egy) the daily water demand could double the normal case (semiaccumulation strategy).
The election of the water tank depends on the next table:
Daily water demand
RAS-(4/5/6)H(V)RNME-AF + RWH-(4.0/5.0/6.0)FS(V)NFE
N O T E
• The storage capacity of the tank has to meet with the daily consumption in order to avoid stagnation of water.
• The YUTAKI S80 is designed for combination with HITACHI Domestic Hot Water Tank. In case of another tank
is being used in combination with YUTAKI S80, HITACHI cannot guarantee neither good operation or reliability
of the system.
• This Domestic Hot Water Tank selection procedure is just orientated, be sure of consulting the local legislation
to ensure a good water demand value.
75
TCGB0075 rev.0 - 11/2012
D
(T)= D
(60ºC) x (60-T
i
i
at 60ºC,
<185 Litres
>185 Litres
YUTAKI S80
/ T-T
)
i
i
D
(60ºC) , it must be referred the current technical
i
Domestic Hot Water Tank
DHWS195S-2.0H1E
DHWS260S-2.0H1E
Domestic Hot Water Tank
DHWS195S-2.0H1E
DHWS260S-2.0H1E
4