Table of Contents
Advertisement
Maintaining the Server
c) Under Boot Option Priorities, verify that the OS you installed is listed as your Boot Option #1.
Replacing a SAS/SATA Drive
Step 1
Remove the drive that you are replacing or remove a blank drive tray from the bay:
a) Press the release button on the face of the drive tray.
b) Grasp and open the ejector lever and then pull the drive tray out of the slot.
c) If you are replacing an existing drive, remove the four drive-tray screws that secure the drive to the tray and then lift
the drive out of the tray.
Step 2
Install a new drive:
a) Place a new drive in the empty drive tray and install the four drive-tray screws.
b) With the ejector lever on the drive tray open, insert the drive tray into the empty drive bay.
c) Push the tray into the slot until it touches the backplane, and then close the ejector lever to lock the drive in place.
Figure 8: Replacing a Drive in a Drive Tray
Replacing a SAS/SATA Drive
Maintaining the Server
15
- Quick Links:
- Rear Panel Leds
- Replacing Fan Modules
Hide quick links:
Advertisement
Table of Contents
