Driving The Machine; Using The Smart Speed Tm Control System - Toro TimeCutter MX 4275T Operator's Manual
Hide thumbs
Also See for TimeCutter MX 4275T:
- Manual (240 pages) ,
- Operator's manual (60 pages) ,
- Operator's manual (60 pages)
Table of Contents
Advertisement
Driving the Machine
The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance. Always operate in the full throttle
position when mowing.
WARNING
The machine can spin very rapidly. You
may lose control of the machine and cause
personal injury or damage to the machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
Driving Forward
Note:
Always use caution when backing up and
turning.
1.
Move the levers to the center, unlocked position.
2.
To go forward, slowly push the motion-control
levers forward
(Figure
Figure 24
position for best
AST
24).
Driving Backward
1.
Move the levers to the center, unlocked position.
2.
To go backward, slowly pull the motion-control
levers rearward
Using the Smart Speed
Control System
The Smart Speed
below the operating position
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow, and mow.
g008952
1. Smart-speed lever
To change speeds, do the following:
1.
Move the motion-control levers to neutral and
outward to the P
24
(Figure
25).
Figure 25
TM
Control-System lever, located
(Figure
26), gives the
Figure 26
position.
ARK
g008953
TM
g293338
- Quick Links:
- Starting the Engine
- Servicing the Engine Oil
Hide quick links:
Advertisement
Table of Contents
