European Community, Switzerland, Norway, Iceland, And Liechtenstein - Cisco Catalyst IR1800 Rugged Series Installation Manual

Hide thumbs Also See for Catalyst IR1800 Rugged Series:

Hardware installation manual (112 pages)

Installation manual (96 pages)

Connecting (4 pages)

Table of Contents

Regulatory Compliance

This device has been designed to operate with antennas having a maximum gain of 8 dBi. Antennas having

a gain greater than 8 dBi are strictly prohibited for use with this device. The required antenna impedance is

50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that

the equivalent isotopically radiated power (EIRP) is not more than that permitted for successful communication.

Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference

to co-channel mobile satellite systems.

Users are advised that high-power radars are allocated as primary users (i.e. priority users) of the bands

5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN

devices.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

European Community, Switzerland, Norway, Iceland, and

Liechtenstein

Cisco

• IR1821

• IR1831

• IR1833

• IR1835

Declaration of Conformity with regard to the R-ED Directive 2014/53/EU

The following standards were applied:

• ETSI EN 301 489-1 V2.2.3; EN 301 489 - 17 v3.2.4

• Draft ETSI EN 301 489-19 V2.2.0 (2020-09)

• Draft ETSI EN 301 489-52 V1.1.2

• Health & Safety-EN 62368-1; EN 50835:2017

• Radio-EN 300 328 v2.2.2; EN 301 893 v 2.1.1 , EN 62311:2019

The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive 2014/53/EU has

been followed.

Note

This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain

frequencies and/or may require a license for operation. For more details, contact Cisco Corporate Compliance.

The product carries the CE Mark:

Catalyst IR1800 Rugged Series Router PIDS

Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide