hit counter script

Example: Displaying Online Diagnostics - Cisco Catalyst 9400 System Management Configuration Manual

Cisco ios xe bengaluru 17.4.x
Hide thumbs Also See for Catalyst 9400:
Table of Contents

Advertisement

Configuring Online Diagnostics
Device(config)# schedule module 3 test TestThermal on October 2 2018 23:00
This example shows how to schedule diagnostic testing to occur weekly at a certain time on a specific switch:
Device(config)# diagnostic schedule module 3 test 1,2,4-6 weekly saturday 10:30

Example: Displaying Online Diagnostics

This example shows how to display on-demand diagnostic settings:
Device# show diagnostic ondemand settings
Test iterations = 1
Action on test failure = continue
This example shows how to display diagnostic events for errors:
Device# show diagnostic events event-type error
Diagnostic events (storage for 500 events, 0 events recorded)
Number of events matching above criteria = 0
No diagnostic log entry exists.
This example shows how to display the description for a diagnostic test:
Device# show diagnostic description module 3 test all
TestGoldPktLoopback :
The GOLD packet Loopback test verifies the MAC level loopback
functionality. In this test, a GOLD packet, for which doppler
provides the support in hardware, is sent. The packet loops back
at MAC level and is matched against the stored packet. It is a
non-disruptive test.
TestFantray :
This test verifies all fan modules have been inserted and working
properly on the board. It is a non-disruptive test and can be
run as a health monitoring test.
TestPhyLoopback :
The PHY Loopback test verifies the PHY level loopback
functionality. In this test, a packet is sent which loops back
at PHY level and is matched against the stored packet. It is a
disruptive test and cannot be run as a health monitoring test.
TestThermal :
This test verifies the temperature reading from the sensor is
below the yellow temperature threshold. It is a non-disruptive
test and can be run as a health monitoring test.
TestScratchRegister :
The Scratch Register test monitors the health of
application-specific integrated circuits (ASICs) by writing values
into registers and reading back the values from these registers.
It is a non-disruptive test and can be run as a health monitoring
test.
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Example: Displaying Online Diagnostics
281

Advertisement

Table of Contents
loading

Table of Contents

Save PDF