Configuring Health-Monitoring Diagnostics - Cisco Catalyst 9200 Configuration Manual
Hide thumbs
Also See for Catalyst 9200:
- Hardware installation manual (128 pages) ,
- Installing manual (8 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Configuring Online Diagnostics
Command or Action
Configuring Health-Monitoring Diagnostics
You can configure health-monitoring diagnostic testing on a Device while it is connected to a live network.
You can configure the execution interval for each health-monitoring test, enable the Device to generate a
syslog message because of a test failure, and enable a specific test.
Use the no form of this command to disable testing.
By default, health monitoring is disabled, but the Device generates a syslog message when a test fails.
Follow these steps to configure and enable the health-monitoring diagnostic tests:
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
enable
configure terminal
diagnostic monitor interval number test {name | test-id | test-id-range | all} hh:mm:ss milliseconds
day
diagnostic monitor syslog
diagnostic monitor threshold number number test {name | test-id | test-id-range | all} failure count
count
diagnostic monitor number test {name | test-id | test-id-range | all}
end
show diagnostic { content | post | result | schedule | status | }
show running-config
copy running-config startup-config
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
Configuring Health-Monitoring Diagnostics
Purpose
• test-id-range—ID numbers of the tests that appear in
the show diagnostic content command output.
• all—All test IDs.
• basic—Starts the basic on-demand diagnostic tests.
• complete—Starts the complete test suite.
• minimal—Starts the minimal bootup test suite.
• non-disruptive—Starts the non-disruptive test suite.
• per-port—Starts the per-port test suite.
You can schedule the tests as follows:
• Daily—Use the daily hh:mm parameter.
• Specific day and time—Use the on mm dd yyyy hh:mm
parameter.
• Weekly—Use the weekly day-of-week hh:mm
parameter.
137
- Quick Links:
- Table of Contents
- Setting the System Clock
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
