Table of Contents
Advertisement
Installing a memory module
Warning! Memory of the identical size, speed, and organization
must be installed in the same colored DIMM slots.
1
Perform the pre-installation instructions described on page 28.
2
Remove the side panel described on page 36.
3
Lay the server on its side (components showing).
4
Install the memory module.
(1) Align the DIMM so that the notch on the slot fits the keyed
edge of the module, then press the module at both ends to
seat it fully in the slot.
If you insert an DIMM but it does not fit easily in the slot, you
have inserted it incorrectly. Reverse the orientation of the
module and insert it again.
(2) Firmly press the holding clips inward to lock the DIMM in
place.
If the holding clips do not close, the DIMM is not properly
inserted.
5
Observe the post-installation instructions described on page 29.
The system automatically detects the amount of memory installed.
Run the BIOS setup to view the new value for total system memory
and make a note of it.
51
- Quick Links:
- Front Panel
- Configuring the Hard Disk Drive
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
