Table of Contents
Advertisement
Operation Manual / 2 Safety / A100-L, A200-L
1 Safety / 1.5 Intended use
1.5
Intended use
Use on internal combustion engines in general
ABB turbochargers are intended for charging internal combustion engines.
The A100-L/A200-L turbochargers are designed for use on 2-stroke engines. These can be
operated with liquid and gaseous fuels.
To ensure compliance with the machinery directive 2006/42/EC when using on gas engines,
the turbocharger must be operated in an engine room classified as "not at risk of explosion".
This is in accordance with the position paper [2] relating to ATEX issued by EUROMOT [1].
The turbocharger supplies the engine with the air volume and associated charging pressure
required for operation.
The turbocharger is solely intended to be operated with a clockwise direction of rotation as
viewed from the turbine end.
The turbocharger is supplied with air from the engine compartment via the filter silencer. If
the air is mixed with cooled exhaust gases via the low-pressure exhaust gas recirculation
(EGR), it must be ensured that these are cleaned as well as possible and that no water
droplets or exhaust gas particles enter the compressor inlet.
The specific operating limits of the turbocharger were determined on the basis of informa-
tion from the enginebuilder about the intended use. These data are given on the rating
plate.
ABB accepts no liability and rejects all warranty claims for any non-intended uses.
[1]Euromot = The European Association of Internal Combustion Engine Manufacturers
[2]Directive 94/9/EC concerning equipment and protective systems intended for use in po-
tentially explosive atmospheres (ATEX) The Euromot Position as of November 2003, ATEX
Euromot Position 191103
WARNING
Unapproved operation
Any operation of the turbocharger outside of its operating limits can be haz-
ardous to personnel.
Only operate the turbocharger within the operating limits.
u
Only trained personnel must operate the turbocharger.
u
The intended use of the turbocharger includes compliance with all regulations and condi-
tions. In particular, the following must be observed:
¡
Operation Manual
¡
Instructions of the enginebuilder
© Copyright 2020 ABB. All rights reserved.
HZTL4024_EN
Rev.E
July 2020
Advertisement
Table of Contents
