en
Operating the appliance
Saturation display
If the metal grease filters or the activated charcoal filter
are/is saturated, the corresponding symbols flashes
after the appliance is switched off:
Metal grease filters:
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
1 and 2
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 10
Note:
The saturation indicator does not apply for non-
renewable activated charcoal filters that are inserted
downstream of the metal grease filter. These activated
charcoal filters must be replaced twice a year.
The saturation indicators can be reset while they are
flashing. To do this, touch the
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
■
symbol.Take your finger off the
will switch the electronic controller over to air
recirculation mode (filters that cannot be
regenerated).
Touch and hold the
■
symbol.Take your finger off the
will switch the electronic controller over to air
recirculation mode (filters that can be regenerated).
Repeatedly touching and holding the
■
and touching the "1" symbol switches the electronic
controller back over to air extraction mode.
Audible signal
Switching on
#
Touch and hold the
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
Switching off
Touch and hold the
#
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
8
#
and 1
#
and 2
#
symbol.
D
symbol. Touch the "2"
D
symbol. This
D
symbol. Touch the "3"
D
symbol. This
D
y
and
symbols at the same
and
y
symbols at the same
#
,
symbol