Cisco 7500 Series Configuration Manual page 162
Cisco systems bridge/router installation and configuration guide
Hide thumbs
Also See for 7500 Series:
- Replacing manual (40 pages) ,
- Configuration manual (50 pages) ,
- Datasheet (11 pages)
Table of Contents
Advertisement
Configuring the Cisco 7500 Series System
Enter the enable secret password and the enable password when the following is displayed:
Step 5
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret: barney
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password: betty
The Simple Network Management Protocol (SNMP) is the most widely supported open standard for
Note
network management. It provides a means to access and set configuration and run-time parameters of
routers and communication servers. SNMP defines a set of functions that can be used to monitor and
control network elements.
Step 6
Enter yes or no to accept or refuse SNMP management:
Configure SNMP Network Management? [yes]: yes
Community string [public]:
Step 7
For the following query, do not enable CLNS:
Configure CLNS? [no]: no
Step 8
For the following queries, enable routing on AppleTalk and IPX:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure IPX? [no]: yes
Step 9
For the following queries, do not enable VINES, XNS, DECnet, or bridging:
Configure Vines? [no]: no
Configure XNS? [no]: no
Configure DECnet? [no]: no
Configure bridging? [no]: no
Step 10
In most cases you will use IP routing. If you are using IP routing, you must also select an interior routing
protocol. You can specify only one of two interior routing protocols to operate on your system using the
setup program: Interior Gateway Routing Protocol (IGRP) or Routing Information Protocol (RIP).
Enter yes (the default) or press Return to configure IP, and then select an interior
routing protocol for IP:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Note
The following sample display includes a continuous listing of all configuration parameters selected in
Step 4 through Step 10. These parameters are shown in the order in which they appear on your console
terminal.
Only IP, IPX, and AppleTalk are the selected protocols for this example.
Configuring global parameters:
Enter host name [Router]:
The enable secret is a one-way cryptographic secret used
Cisco 7500 Series Installation and Configuration Guide
4-14
Your IGRP autonomous system number [1]: 15
Chapter 4
Performing a Basic Configuration of the System
OL-5008-03 B0
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
