Table of Contents
Advertisement
Chapter 3
Installing Components
Press y and Enter to continue. The program then lets you decide if you are going to be provisioning voice
Step 11
technology devices. For example:
Are you going to use a device(s) that supports PacketCable voice technology?
If you are going to use PacketCable devices we need some more info.
Enter Yes to Install PacketCable and No if you do not want Packetcable
installed [No]: yes
Step 12
Press y if you are using voice technology devices or n if you are not. If you are not using voice
technology devices, you will be prompted to enter a shared secret password as described in Step 14. If
you press y, the program will prompt you to enter several voice technology properties. For example:
Enter KDC Realm Name
Enter the IP Address of the Primary DHCP Server.
Enter the IP Address of the Primary DNS Server.
Enter the IP Address of the Secondary DHCP Server.
Enter the IP Address of the Secondary DNS Server.
Step 13
Press y and Enter to continue. The program prompts you to enter the shared secret password.
Note
Step 14
Enter the password that you want to use for authentication among BACC servers. For example:
Shared Secret Password
Enter the password to be used for authentication
among the BPR servers.
If you are performing a lab installation, then the password will be used for all the
servers.
same as the components previously installed.
Enter the Shared Secret Password [secret] changeme
The program prompts you to confirm the password.
Step 15
Enter the password again.
Step 16
Press y and Enter to continue. The program then displays the installation parameters you have selected.
For example:
Installation Parameters
This screen shows the installation parameters that you have chosen:
========== Confirmation ==========
The Component Installation will use the following parameters
to install the NR Extension Points component:
Home directory:/opt/CSCObpr
Data directory:/var/disk0/CSCObpr
NR extension point provisioning group:group1
Step 17
Press y and Enter to install the Network Registrar extensions. The program displays a message when
the installation is complete.
OL-19105-01
ACME.COM
You must use the same shared secret password for all BACC servers on your network.
If this is a component installation, then the password you enter must be the
10.10.10.1
10.10.10.3
10.10.10.2
10.10.10.4
Cisco Broadband Access Center for Cable Installation Guide 2.7
Installing Components Using the CLI
3-13
Advertisement
Table of Contents
