Table of Contents
Advertisement
Installing in a Lab Environment Using the GUI
Installing in a Lab Environment Using the GUI
The lab installation prompts for this information:
•
•
•
During a lab installation, a set of predetermined default values are used as a network configuration.
To install BACC in a lab environment, complete these steps:
Complete steps 1 through 4 in the
Step 1
Click Lab when the Choose Installation Type screen appears.
Step 2
Click Next. The lab installation program automatically checks to see if it detects a TFTP server.
Step 3
Caution
Provided that a TFTP server is not detected, a PacketCable voice technology screen appears.
Step 4
Determine if you need to install the voice technology option and click:
•
•
Click Next and the Destination Directory screen appears.
Step 5
Enter the pathname of the location where you want to install BACC.
Step 6
Click Next. The installation program verifies that the selected installation directory exists and, if it does
Step 7
not, prompts you to automatically create it. The installation program also confirms that the required disk
space is available, and then the Cisco Network Registrar Username and Password screen appears.
Enter the Network Registrar administrative username and password.
Step 8
Click Next. The Key Distribution Center Realm Name screen appears.
Step 9
If the default KDC realm name is inappropriate, enter desired KDC Realm, FQDN, and interface address
Step 10
name.
Click Next. The PacketCable Properties screen appears.
Step 11
Note
Enter the appropriate information into the fields shown.
Step 12
Cisco Broadband Access Center for Cable Installation Guide 2.7
4-2
BACC destination directory
Network Registrar administrator username and password
Shared secret password
When installing BACC on a Solaris server, both the Solaris and Network Registrar TFTP
servers must be disabled.
Yes button if you want to install the voice technology option
No if you do not have a valid license key for this technology.
If you did not select the voice technology option from the PacketCable Panel, this screen will
not appear.
"Installation Using the Graphical User Interface" section on page
Chapter 4
Installing in a Lab Environment
OL-19105-01
2-7.
Advertisement
Table of Contents
