Table of Contents
Advertisement
Connecting the Router to Your Local Network
Be sure to read the safety information in the Regulatory Compliance and Safety
Information for the Cisco 1600 and Cisco 1700 Routers document that came with
your router.
Read the installation instructions before you connect the system to
Warning
its power source.
Warning
This equipment needs to be grounded. Use a green and yellow 14
AWG ground wire to connect the host to earth ground during
normal use.
Warning
Do not work on the system or connect or disconnect cables during
periods of lightning activity.
Do not place anything on top of the router that weighs more than
Caution
10 pounds (4.5 kg). Excessive weight on top of the router could
damage the chassis.
Connecting the Router to Your Local Network
The router is connected to your local Ethernet network through the yellow 10/100
Ethernet port. You must provide the following items for this connection:
Warning
The ports labeled
safety extra-low voltage (SELV) circuits. SELV circuits should only
be connected to other SELV circuits. Because BRI circuits are
treated like telephone-network voltage, avoid connecting the
SELV circuits to the telephone network voltage (TNV) circuits. (To
Cisco 1750 Router Hardware Installation Guide
ii
A straight-through, RJ-45-to-RJ-45 Ethernet cable
•
A 10/100-Mbps Ethernet hub or switch
•
10/100-Mbps Ethernet port and Console port are
78-6169-02
Advertisement
Table of Contents
Troubleshooting
