Connecting To Dual-Purpose Ports; Connecting To 100Base-Fx Ports; Verifying Port Connectivity - Cisco IE 3000 Getting Started Manual
Cisco systems switch user manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (186 pages) ,
- Command reference manual (802 pages)
Table of Contents
Advertisement
Connecting to Dual-Purpose Ports
Step 1
Insert either an RJ-45 connector to the 10/100/1000 port (see the
10/100/1000 Ports" section on page
and connect a cable to the SFP module port. (See the
to Ports" section on page
Step 2
Insert the other cable end into the other device.
Connecting to 100BASE-FX Ports
Step 1
Insert an LC cable into the 100BASE-FX port
of a Cisco IEM-3000-8FM expansion module.
Step 2
Insert the other cable end into the other device.
Verifying Port Connectivity
Cisco IE 3000 Switch Getting Started Guide
24
Only one port on a dual-purpose port can be active at a time. If both ports are
connected, the SFP module port has priority.
Follow these steps:
23.)
Follow these steps:
After you connect to the switch port and another device, the port LED turns amber
while the switch establishes a link. This process takes about 30 seconds, and then
the LED turns green when the switch and the target device have an established
link. If the LED is off, the target device might not be turned on, there might be a
cable problem, or there might be a problem with the adapter installed in the
target device.
22), or install an SFP module into the SFP module slot,
"Installing SFP Modules and Connecting
Cisco IE 3000 Switch Getting Started Guide
"Connecting to 10/100 and
OL-16234-01
Hide quick links:
Advertisement
Chapters
Table of Contents
