Connecting To Wireless Devices; Overview Of Connected Devices - Siemens RDS110.R User Manual

Smart thermostat wireless

Hide thumbs Also See for RDS110.R:

Table of Contents

5 Connecting to wireless devices

A6V11562455_en--_d

Acting as a Thread router, the thermostat can connect to a maximum of six

wireless relays (RCR114.1) or valve actuators (SSA911.01TH) to control your

heating system remotely. If a relay or actuator fails to connect to the thermostat

due to low signal strength (distance or blockades [walls, and so on.]), you can

install a maximum of three wireless repeaters (RCR114.1) in between to extend

the reach of the RDS110.R control signals.

Once the connection between the thermostat and the wireless devices has been

established, no manual re-connection is needed, even if a power supply

interruption should occur.

NOTICE

●

You cannot manually turn ON/OFF RCR114.1.

●

RCR114.1 and SSA911.01TH cannot be connected to the thermostat at the

same time unless RCR114.1 is configured as a repeater. See the

of RCR114.1 for information about how to configure it as a repeater.

●

If pairing fails the first time, wait five minutes before trying again.

Tap to change name and see valve position (SSA911.01TH only)

Wireless repeater (RCR114.1 only)

Relay or actuator (RCR114.1 or SSA911.01TH)

Signal strength of the connected device

Tap to remove a device.

Communication failure

Low battery (SSA911.01TH only)

Tap to view all devices.

Tap to add more devices.

Connecting to wireless devices

Overview of connected devices

Quick guide

21 | 60

Table of Contents