Emi And Radio Frequency Interference - Cisco Catalyst 9500 Series Hardware Installation Manual

Hide thumbs Also See for Catalyst 9500 Series:

Table of Contents

Preparing for Installation

EMI and Radio Frequency Interference

A type of corrosion known as creep corrosion, that primarily affects PCBA (Printed Circuit Board Assembly)

occurs when the PCBA is subjected to a harsh, and sulfur-rich (hydrogen sulfide) end-use environment over

a prolonged period of time. The corrosion begins on certain exposed metals, such as copper and silver, and

then creeps along the remaining metal surface either causing electrical short circuits or creating holes. Creep

corrosion also occurs on electronic components such as resistors and PCBs.

To prevent corrosion, remove or minimize the presence of dust and particulates at the installation site by

following the guidelines mentioned in ANSI 71-04-2013 regulations.

Figure 8: A PCB with Corrosion on its Metal Contacts

EMI and Radio Frequency Interference

Electro-Magnetic interference (EMI) and radio frequency interference (RFI) from a system can adversely

affect devices such as radio and television (TV) receivers operating near the system. Radio frequencies

emanating from a system can also interfere with cordless and low-power telephones. Conversely, RFI from

high-power telephones can cause spurious characters to appear on the system monitor. RFI is defined as any

EMI with a frequency above 10 kilohertz (kHz). This type of interference can travel from the system to other

devices through the power cable and power source, or through the air in the form of transmitted radio waves.

The Federal Communications Commission (FCC) publishes specific regulations to limit the amount of EMI

and RFI emitted by computing equipment. Each system meets these FCC regulations. To reduce the possibility

of EMI and RFI, follow these guidelines:

Cisco Catalyst 9500X Series Switches Hardware Installation Guide

Table of Contents

Show Quick Links

Table of Contents

C9500x-28c8d C9500x-60l4d