Table of Contents
Advertisement
global_main.book.book Page 11 Wednesday, May 11, 2022 9:31 AM
Connecting the Water Inlet
Hoses
Before connecting the water inlet hose to the water
tap, check the hose fitting type and follow the
instructions for that hose fitting.
Note for Connection
• Water supply pressure must be between 50 kPa
and 800 kPa (0.5 - 8.0 kgf / cm²). If the water
supply pressure is more than 800 kPa, a
decompression device should be installed.
• Do not overtighten the water inlet hose to the
valve.
• Periodically check the condition of the hose and
replace the hose if necessary.
Checking the Rubber Seals
Two rubber seals
are supplied with the water
a
inlet hoses. They are used to prevent leaks when
the connections to the taps are properly tightened.
Do not over tighten connections.
• Do not use mechanical devices such as multi
grips to tighten the inlet hoses. Ensure that the
curved end of the water inlet hose is connected
to the appliance.
INSTALLATION
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap with Thread
Screw the hose connector onto the water supply
tap. Hand tighten only with the aid of a soft cloth.
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
Connecting the Hose to the
Appliance
Screw the water inlet hose to the water inlet valve
on the back of the appliance.
• On models with only one water inlet, do not
connect the hose to the hot water supply.
Connect to the cold water supply only.
NOTE
• After completing the connections, check for
leaks and tighten or reassemble the connections
if needed.
11
Advertisement
Table of Contents
