Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Husqvarna LFe 60
Summary of Contents for Husqvarna LFe 60
- Page 1 LFe 60 Operator's manual 2-26...
-
Page 2: Table Of Contents
Contents Introduction..............2 Transportation, storage and disposal......18 Safety................5 Technical data.............. 21 Operation..............11 Accessories..............24 Maintenance..............13 Declaration of Conformity..........25 Troubleshooting............17 Introduction Product description • A = Water tank for compaction of asphalt is included. • T = Transport wheels are included. The product is a walk-behind light forward plate Intended use compactor with an electric motor. - Page 3 Product overview front 11 12 ALERT ERROR 1. Handle 12. "ERROR" indicator for the battery 2. Upper handle 13. Battery handle 3. Handle knobs 14. Battery (not included) 4. Lift point 15. Battery connector 5. Eccentric element 16. Air intake 6.
- Page 4 Product overview rear Symbols on the product 1. Battery cable 2. Battery fastener lever WARNING: This product can be 3. Transportation wheel dangerous and cause serious injury or 4. Transportation wheel lever death to the operator or others. Be careful 5.
-
Page 5: Safety
1. Rated voltage 2. IP classification 3. Product type Wear approved hearing protection. 4. Product number 5. Product weight 6. Serial number 7. Manufacturer To lift the product, attach lifting equipment to the lift point on the product. 8. Rated power 9. - Page 6 protection used for appropriate conditions will reduce Note: Save all warnings and instructions for future personal injuries. reference. The term "power tool" in the warnings refers • Prevent unintentional starting. Ensure the switch is to your mains-operated (corded) power tool or battery- in the off-position before connecting to power source operated (cordless) power tool.
- Page 7 grasping surfaces do not allow for safe handling and • Never service damaged battery packs. Service of control of the tool in unexpected situations. battery packs should only be performed by the manufacturer or authorized service providers. • Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of General safety instructions electric shock.
- Page 8 • Do not operate the product without all protective • Symptoms can occur during operation of the product covers installed. or at other times. If you have symptoms and continue to operate the product, the symptoms can • Use personal protective equipment. Refer to increase or become permanent.
- Page 9 • Do a check of the safety devices regularly. If the Noise safety safety devices are damaged or do not operate correctly, speak to your Husqvarna service agent. WARNING: Read the warning • Do not make modifications to safety devices.
- Page 10 Use batteries that are rechargable as a power supply Make sure that the battery charger is not covered. for the related Husqvarna products only. To prevent Pull out the plug to the battery charger if there is injury, do not use the battery as a power supply for smoke or fire.
-
Page 11: Operation
• Make sure that the work area is safe. Wet and loose • Disconnect the product from the power source soil decreases safe operation of the product. Be very before you do the maintenance. careful on slopes and rough surfaces. •... - Page 12 To charge the bat- battery. Refer to tery on page 15 . Water tank For LFe 60 there is an optional water tank for compaction of asphalt. CAUTION: Do not add other fluids than water to the water tank. Other fluids can cause damage to the product and be •...
-
Page 13: Maintenance
To set the product in operation position 2. Lower the handle (B). 3. Tighten the handle knobs (A). 1. Loosen the handle knobs (A). To adjust the water flow • Turn the water tap (A). Adjust the water flow between closed (B) and fully open (C) mode. 2. - Page 14 General product maintenance Before use, Weekly, each 10 h each 100 h Do a general inspection. Clean the product. Make sure that nuts and screws are tightened. Make sure that the "STOP" button operates correctly and is not defective. Examine the battery for damage. Examine the battery charger for damage and make sure that it operates correctly.
- Page 15 3. Tilt the battery and remove the battery from the 4. Push the battery fastener (A) up to lock the battery. battery holder. 5. Remove the cap (B) from the battery cable. 4. Install the cap (C) to the battery cable. 6.
- Page 16 4. Put the battery in the center of the battery charger. 2. Remove the 4 screws that hold the V-belt cover and remove the V-belt cover. 5. Connect the battery charger connector (B) to the 3. Examine the V-belt for damages and wear. Replace battery to charge the battery.
-
Page 17: Troubleshooting
Troubleshooting Problem Cause Solution The product does not start. The battery is not installed correctly. Install the battery correctly. Make sure that the battery cable is connec- ted to the product. Low battery voltage. Charge the battery The battery is defective. Replace the battery. -
Page 18: Transportation, Storage And Disposal
Indicator Cause Solution "ALERT" "ERROR" Battery status Flashes Battery error. Disconnect the battery and wait for approximately 5 minutes. Push the battery check button. If the "ALERT" indicator goes off, the product can be used. 4 LEDs in the Overvoltage. Disconnect the battery and wait state of charge for approximately 5 minutes. - Page 19 To engage the transport wheels (optional) WARNING: Do not use metal • Push the transport wheel lever (A) to fold the hooks, chains or other lifting equipment transport wheels (B) down, below the bottom plate. with rough edges that can cause damage to the lifting point.
- Page 20 • Do not keep the battery in area where static electricity can occur. Do not keep the battery in a metal box. • Clean the product before storage. • Put a protective cover on the product. • Keep the product in a dry and frost free area. •...
-
Page 21: Technical Data
Technical data Technical data Product LFe 60, light forward compactor Motor type Honda, GXE2.0H Weight with battery, kg/lb 88/194 Weight without battery, kg/lb 78/172 Vibration frequency, Hz/rpm 95/5700 Amplitude, mm/in. 2/0.08 Centrifugal force, kN/lbf 10.4/2338 Operation speed, m/min or ft./min 22 or 72 Max. - Page 22 Noise and vibration emissions Sound power level, guaranteed L dB (A) Sound pressure level at the operator's ear, L , dB (A) Vibration level, a , m/s , standard handle/low vibration handle 6.9/1.6 Weights for options Transport wheel, kg/lbs 3.1/6.9 Low vibration handle, kg/lbs 1.1/2.4 Noise and vibration declaration...
- Page 23 Product dimensions (LFe 60) Length including handle, Height, mm/in. 1002/39.5 588/23.1 mm/in. Handle height, mm/in. Height with handle folded, 965/38 608/24 mm/in. Bottom plate contact area, Length with handle folded, 0.090/0.97 850/33.5 /sq. ft. mm/in. Length bottom plate, Width, mm/in.
-
Page 24: Accessories
Accessories Approved battery Battery DP72104Z Type Lithium-ion Capacity, Ah Voltage DC, V Weight, kg Approved battery charger Battery charger CV7285Z Mains voltage AC, V 100-240 Frequency, Hz 50-60 Output voltage DC, V 82.8 Output current, A 1661 - 002 - 13.03.2023... -
Page 25: Declaration Of Conformity
Declaration of Conformity EC Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Forward Plate Compaction Machine Brand Husqvarna Type/Model LFe 60 Identification Serial numbers dating from 2022 and onwards... - Page 26 UK Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, SWEDEN, Tel: +46 36 146500 declare on our sole responsibility that the product: Description Forward Plate Compaction Machine Brand Husqvarna Type/Model LFe 60 Identification Serial numbers dating from 2022 and onwards...
- Page 27 1661 - 002 - 13.03.2023...
- Page 28 www.husqvarnaconstruction.com Original instructions 1142691-26 2023-03-21...