Sanyo LNS-S02K Series Lens Replacement Manual

Sanyo lns-s02k projector-lens: install guide

Download this manual

LCD PROJECTOR LENS

MODEL NO. LNS-S02K Series

LENS REPLACEMENT PROCEDURE

Lens replacement should be performed by the qualified service personnel.

It should be followed by this procedure precisely.

Before attempt to replace the lens, confirm the model number (both the LCD

projector and the lens) and use the proper lens.

If you have any questions, contact to the dealers.

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet cover installation after

the lens replacement.

1. Confirm the proper wiring and the wires are fixed properly.

2. Confirm the each connector is connected properly.

3. Wiring must not be tangled in the gear of the lens motor or the other

mechanical part.

4. There is no missing part, or no loosing mounting part.

ICPF/ICPR/ICPS

NOTES ON LENS REPLACEMENT

PARTS LIST

Following parts are contained in the packing.

· LENS

· LENS MOUNTING SCREWS

· DRIVER

· LIGHT-BLOCK SHEET

· LENS COVER

1 piece

6 screws (2 for spare)

1 piece

1 sheet

1 set

1AA6P1P1987-- (ICPF)

Page 1: Parts List
LCD PROJECTOR LENS MODEL NO. LNS-S02K Series LENS REPLACEMENT PROCEDURE NOTES ON LENS REPLACEMENT Lens replacement should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to replace the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.
Page 2 LENS REPLACEMENT PROCEDURE Perform the steps REMOVE THE LENS COVER. (See figure-1.) 1. Turn on the LCD projector. 2. Adjust the lens shift, so that lens is set in the center. 3. Turn off the LCD projector and disconnect the power cord from the AC outlet. 4.
Page 3 INSTALL THE LENS. (See figure-3) Remove protective caps(front and back) on the lens. Mount the lens on mounting bracket main cabinet screws.Use the screws included with the lens. Use the driver included with the lens to fasten the screws. (After using, save it for latter use.) Connect the lead connector of the lens motor to the “K16B”...